Filter
Top Products
Using the TV’s Features
Chapter 3 37
The buttons on the remote control that
operate the PIP feature include: the four
arrow buttons, CH CTRL, PIP, and SWAP.
Arrow
buttons
STOP PAUSE
TV
ON OFF
AUX
DVD
PIP
SWAP
REC•VCR+
RESETCH CTRL
PLAY FORWARDREVERSE
SOUND
GO BACK
C
H
+
C
H
-
V
O
L
V
O
L
SKIPMUTE
INFO
MENU
CLEAR
GUIDE
ANTENNA
1
2
3
4
5
6
7
8
9
0
INPUT
VCR
VPORT
OK
SAT•CABLE
PIP
buttons
PIP Buttons: General Explanation
The buttons on the remote control that you’ll use for the PIP feature are
explained below:
PIP Press the PIP button to make the PIP window appear on the screen. Press
PIP again to remove the window.
Note: If you selected Alternate with PIP button in the PIP Closed-Caption Display
menu, press the PIP button when the PIP window is on the screen to see closed-
captioning in the PIP window.
Arrow buttons (left, right, up, and down) Move the PIP window to
different areas of the screen.
CH CTRL (channel control) Lets you switch channel control between the PIP
window and the main picture. To determine whether the remote control is the
PIP picture or the main picture, look at the TV screen: the yellow channel
number is the one you are controlling. Press CH CTRL to change which picture
you’re controlling.
SWAP Switches, or “swaps,” where the two pictures appear on the TV screen.
The smaller PIP picture swaps to the main screen and the main picture goes to
the little PIP window.
Skip to PIP: Channel Surfing in the Main Picture
You can surf through the channels during commercial breaks using the SKIP
and CH (channel) buttons.
1. Press SKIP to set the commercial skip timer on the channel you are
watching (PIP window appears).
2. Press the CH+ or CH- button to surf through the channels in the main
picture. When the SKIP feature times out, the main picture tunes to the
original channel automatically and the PIP window disappears.
How To Use PIP With A Cable Box
1. The TV must be on. Tune to the channel you want to watch.
2. Press the PIP button on the remote (the PIP window appears with the
same picture in it as the main picture).
3. Turn on the VCR.
4. If the picture gets fuzzy, press the TV/VCR button on the VCR.
5. To see a different picture in the PIP window:
• Press the TV button on the remote control.
• Press the INPUT button on the remote until you see the picture that’s
coming from the VCR (PIP VID appears on the screen).
6. To change the picture in the PIP window, you need to change the channel
on the VCR because the VCR is the second signal source.
Press the channel buttons on the VCR or on the VCR’s remote control.
7. To change the channel in the main picture, press CH CTRL until the main
channel number appears highlighted (yellow). Press the channel up or
down button on the remote control.
Note: Channel up and down tunes to the video input channels when the VID
channel is highlighted (yellow).