Filter
Top Products
20 Chapter 2
Using the Remote Control
Graphics contained within this publication are for representation only.
Chapter 2 21
Using the Remote Control
Graphics contained within this publication are for representation only.
5. With the remote controls facing each other and no more than 2 inches apart, press and hold the button of the
component’s remote control that has the functionality you are recording to the TV’s remote control. Keep pressing
the button until the TV/DVD remote’s component button light turns off and back on (the function has been saved to
the TV/DVD remote). If all component buttons ash four times, then the function wasn't learned. You can try again
starting with step 4.
6. The TV/DVD remote control remains in “learning mode” so you can continue adding functions to different buttons
by repeating steps 4 and 5. Or, press CLEAR to exit learning mode.
Notes: If you want a new function on a button, you must record (learn) over it.
The amount of memory each learned function uses in the TV’s remote control varies. If your TV/DVD remote is out of
memory, the component button(s) light ashes 4 times and turn off, exiting you from the Learning mode.
Clearing a Learned Function
To delete a learned button function, use the procedure below.
1. Press and hold the component button (the component button lights). Then press and hold the CLEAR button for 3
seconds. Continue depressing both buttons (the component mode button ashes—turns on and off again).
2. Release the component and CLEAR buttons (the component button being programmed turns on). Remote is now in
Clear learned function mode.
3. Press and release the button where learning is to be cleared. The component button blinks off then back on—the
learned function was cleared successfully.
4. Repeat steps 1 through 3 until all buttons’ learned functions have been cleared.
Note: If an invalid button is pressed, the component mode button(s) ashes 4 times and the selected component
button stays on and remote remains in Clear Learned Function mode. Repeat step 3.
5. Press the CLEAR button and your TV/DVD remote returns to its original operation mode.
Deleting ALL Learned Functions
This procedure erases all learned functions in every component mode of the remote.
1. Press and hold the CLEAR button (the current component button lights). Then press and hold the ON•OFF button
(component button light turns off for 3 seconds, ashes, turns on and off) while continuing to hold CLEAR.
2. Release both buttons (current component button turns on).
3. Press any component button to delete all learned functions in all modes. Remote is automatically exited from this mode.
Note: Pressing the CLEAR button will NOT delete all learned functions, but will exit the Delete mode.
Volume Punchthrough
You may nd this feature helpful if you’ve connected your components to an audio/video receiver (A/V receiver) or
amplier, but you want to use the TV’s remote control to operate the volume for a component that is connected to the
audio/video receiver. An example follows.
Let’s say you’ve connected your DVD player to your audio/video receiver. You’ve also programmed your TV/DVD remote
control to operate your DVD player. Since the DVD player gets its volume through the audio/video receiver, you would have
to bounce back and forth between two remote controls: the a/v receiver’s remote to adjust the volume and the TV’s remote
control to operate the DVD player.
The Volume Punchthrough Feature eliminates the need for you to use two remote controls and saves a button press when
you’re using the TV/DVD remote to adjust the volume. In effect, you are telling the TV/DVD remote to retrieve and send
volume commands from the A/V receiver whenever the TV/DVD remote is operating the DVD player (in DVD mode).
Continues on next page...