Filter
Top Products
Chapter 1: Connections and Setup
Chapter 110
Installing TV on Suspension Arm - J12H770-NO3 / J12H770-NO4
The J12H770 is designed to attach to a wall mounted suspension arm capable of supporting a television
weighting 14 pounds. The single coaxial cable on top of the unit is used to supply either low voltage DC
power (24 volts) and the RF signal to the television.
CAUTION: DO NOT REMOVE the Beige silicon cover from the swivel assembly. This swivel assembly is factory
preassembled and adjusted. There is no need to remove the cover.
IMPORTANT: These instructions detail installing the TV onto the FC-80 suspension arm. This arm is configured
specifically for this television. The J12H770 may be installed on other FC Series arms.
DANGER: ARM RECOIL HAZARD The safety brake pin must remain in the SAFETY BRAKE PIN HOLE
whenever the television set is removed from the arm or when the arm is removed from the wall
bracket to prevent the arm from springing open.
Male RF
Cable
Female Composite Cable
(Video, Audio L/R)
Female 3.5mm Stereo Cable
(RS232C)