Filter
Top Products
Things to Consider Before You Connect
Protect Against Power Surges
• Connect all devices before you plug any of their power cords into the wall outlet or power
strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
•Turn off the TV and/or device(s) before you connect or disconnect any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safety.
Instructions at the beginning of the User's Guide
•Protect Devices from Overheating.
• Don’t block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
• Don’t stack devices.
• If you place devices in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air
from it won’t flow around other devices.
Position Cables Properly to Avoid Audio Interference
•Insert each cable firmly into the designated jack.
• If you place devices above the TV, route all cables down the side of the back of the TV
instead of straight down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft
or indirect lighting.
Check Supplied Parts
Check that the following parts were packed with your product.
Note: If you need to replace your remote, call 1-800-338-0376. A shipping and handling
fee, and the appropriate sales tax, will be charged upon ordering. Have your Visa,
MasterCard, or Discover Card ready.
Remote control
Chapter 1: Connections and Setup
Chapter 1 Graphics contained within this publication are for representation only. 5
MENU
F
A
V
23
4
5
6
7
8
9
1
0
CH
CH
VOL VOL
CLEAR
I
N
P
U
T
SUB CH
OK
INFO CC SOUND
ZOOM- ZOOM+ PICTURE
SLEEP
GUIDE PRESETS
POWER MUTE
GO BACK
2 AAA batteries Power cord two (2) table stand feet four (4) M5 x 16 screws