Filter
Top Products
12 Chapter 2
Using the Remote Control
Graphics contained within this publication are for representation only.
DVD Puts the remote in DVD mode and, if auto tuning is enabled, will turn on the TV and
tune to the correct video input channel. Also used with the ON•OFF button to turn on other
compatible DVD players.
GUIDE If you’re operating another component that has an on-screen program guide, this
button accesses the on-screen guide.
OPEN•CLOSE In DVD mode, opens or closes the DVD disc tray.
REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE If programmed, provides transport
control for some remote-controllable VCRs or DVD players.
SEARCH In VCR mode, accesses Index Search feature.
SPEED In VCR mode, selects a recording speed.
VCR Puts the remote in VCR mode and, if auto tuning is enabled, will turn on the TV and
tune to the correct video input channel.
ZOOM In DVD mode, zooms in on the picture.
Using the INPUT Button
Use the INPUT button to scroll through the available video input channels and view
components you have connected to the TV.
1. Make sure the component you want to view is turned ON.
2. Press INPUT to tune to an available video input source and view the component.
3. To return to the previous channel, continue pressing INPUT.
You’ll use these buttons when
you program the remote.
DVD
ON OFF
VCR TV
VOL
MUTE GO BACK
CH
CLEAR
MENU
PRESETS
CC
GUIDE
INFO
SKIP
123
4
56
7
89
0
INPUT
ANTENNA
REVERSE
PLAY
FORWARD
RECORD
STOP
PAUSE
AGAIN
ZOOM
OPEN CLOSE
SPEED
SEARCH
OKOK
Programming the Remote to
Operate Other Components
The universal remote can be programmed to operate most brands of
remote controllable components. The remote is already programmed
to operate most RCA, GE, and Proscan components.
Notes: The TV button can’t be programmed on this remote.
The remote may not be compatible with all brands and models
of components. It also may not operate all functions of the
remote that came with your component.
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed
for your component, turn the component ON. For example, to
program the remote for a VCR, turn on the VCR. Point the remote at
the VCR, and press the VCR button. Then press ON•OFF or CH +
(channel up) or CH – (channel down) to see if the VCR responds to
the remote commands. If the component does not respond, the remote
needs to be programmed.
Programming the Remote
There are two ways to program the remote control:
• automatic code search
• direct entry
DVD
and VCR
buttons
ON•OFF
button
REVERSE
and PLAY
buttons
STOP
button
CLEAR
button
16394790.02 Remote 4/12/04, 6:33 PM12