Filter
Top Products
48 Chapter 4
Using the TV’s Menu System
Setup Menu
The Setup menu lets you configure the TV to fit its surroundings and your
preferences. To access the Setup menu, press MENU on the remote, and then
select Setup from the main menu.
Channel setup
Signal source Allows you to set which tuner you want to search for
channels. You can select Analog tuner or Digital tuner to search that tuner
separately, or you can select Both to search both tuners.
Analog Signal Type (available for the analog tuner only) The analog
signal type was set during the initial setup. If you change how you receive
broadcasts through the antenna input, you must change the Signal type
setting. Choose Cable if you are using cable or a cable box for TV signals.
Choose UHF/VHF Antenna if you are using an off-air antenna for analog TV
signals.
Auto channel search Searches for channels the current tuner (analog or
digital) is receiving. Go to page 16 for more information.
Auto channel update Searches for any new channels that are not in your
channel list for the current tuner and adds them to that list.
List and labels Edit the channels in the list or choose labels for each
channel. Go to page 17 for more information.
Preferences
Language Allows you select your preferred language for the menus:
English, Español or Français.
Maximum TV volume Allows you to set how high volume turns up when
you press the VOL+ button. Highlight Maximum volume, then press and
hold OK to hear the maximum volume. Make sure the volume has not been
muted or turned down all the way.
Curtain effect Reveals the picture by "opening" it from the middle of the
screen when the TV is switched on. Hides the picture by "closing" it from
the sides when the TV is switched off.
Special features The Auto on setting switches your TV on after a power
outage; Auto channel tunes the TV to the channel you specify as the Initial
channel when Auto on is enabled; Auto volume tunes the TV to the volume
you set in Initial volume when Auto on is enabled.
Channel setup
Go back
Signal Source
Analog Signal type
Auto channel search
Auto channel update
List and labels
Both...
Cable...
Start
Start
...
Press < / > to select where you would like to
search for channels.
Go back
Channel setup
Preferences
Closed caption
Autotuning
Convergence
...
...
...
...
...
Setup
Short-term vs. Long-term
Power Outages
The Auto channel and Auto volume settings
don’t take effect after short-term power
outages (usually less than two to three
minutes). The TV will turn back on at the same
volume and channel as before the power
outage.
The Auto channel and Auto volume settings
take effect after power outages of several
minutes or more.
Go back
Language
Maximum TV volume
Curtain effect
Special features
English...
...
Preferences
Select your language using < or > keys.