Filter
Top Products
11
RCU800
Code Search Methods
Manual Code Search
1. Manually turn on the component you want the remote
to operate.
2. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
3. Press and release the component key that corresponds to the
component you want the remote to operate (TV, VCR, DVD,
DBS•SAT, CABLE, AUDIO). For an auxiliary component,
press the AUX key, then the corresponding component key. For
CD, press the AUX key, then the DVD key. The indicator light
blinks once and then remains lit.
4. Aim the remote at the component. Press the ON•OFF key
continuously until the component turns off.
Important: Because there are so many codes, you may have to
press the ON•OFF key many times—possibly up to 200 times.
5. When the component turns off, press the ENTER key
to store the code.
6. Use the Code Retrieval section on the next page to identify
the code for your component for future reference.
Auto Code Search
1. Turn on the component you want the remote to operate.
2. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
3. Press and release the component key that corresponds to
the component you want the remote to operate (TV, VCR,
DVD, DBS·SAT, CABLE, AUDIO). For an auxiliary component,
press the AUX key, then the corresponding component key. For
CD, press the AUX key, then the DVD key. The indicator light
blinks once and remains lit.
4. Aim the remote at the component and press the ON•OFF
key once
. The remote automatically sends every code for
the specified component one at a time, with the three-second
delay between each code. Keep the remote aimed at the
component throughout this process.
5. As soon as the component turns off, you must press the
ENTER key immediately so the remote stores the correct
code. If you do not press the ENTER key within three seconds,
the remote sends the next code in the list, and you will have
to start over from step 2.
6. Use Code Retrieval section on the next page to identify
the code for your component for future reference.
If your component’s brand is not listed in the Code List or you have tried all the codes for your
brand and the remote does not operate your component, use one of the Code Search methods below—
Manual Code Search or Auto Code Search. Both Code Search methods search all of the codes since
your component’s code may be listed under another brand in the Code List.
Note: The Code Search method may take a long time because the remote searches all of the codes in
its memory for the code that operates your component. Therefore, if your brand is listed in the
Code List, use the Direct Entry method described on pages 5-9.
(OFF)
(BLINK)
CODE
SEARCH
INDICATOR
LIGHT
CODE
SEARCH
INDICATOR
LIGHT
(OFF)
ON•OFF
ENTER
ON•OFF
ENTER
(BLINK)
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 11