RCA VPT 385 VCR User Manual


 
Programming the Timer (continued)
f
151
The display will prompt you to select either
AM or PM.
ON C" J--I
[] NORM I
Press "1'" for AM or "2" for PM.
The display will prompt you to select the
[6] stopping time.
,,I/ AM I"_ J..._[
OFF -- ,..CH Jl,.,,,.I
/1"
] NORM
Press four digits, two for the hour and two more
for the minute. For example, press 0 8 0 5 for 8:05.
(Always press "0" before a single-digit hour or
minute. The "0 +' will not appear in the display.)
171
The display will prompt you to select either
AM or PM.
D4
oFF LI" U_I ;orcH
] NORM
Press "1" for AM or "2" for PM.
181 The display' will sho_ "START DATE"
followed by the current date and day.
DATE SUN
,_,, lo o'l
J E!
] M NORM D
If you want to start recording on the current
day. skip to Step 9.
If you want to start recording on a future
date, press four digits (two for the month and
two for the day). Press "0" first for a single-
digit month or day. For example, press 0 7 0
9 to begin recording on July 9.
The year and day of the week are displayed
automatically when you finish.
r 1
19] Press PROGRAM to enter your program and [110]
return to the clock display. Additional programs
may be entered by repeating steps 2-9.
-Checking the Timer Programs
Programs can be checked whenever the VCR is turned
on.
I. Press PROGRAM on the remote hand unit to
display the programming menu.
2. Press 5 (Program Review).
The display will show the START TIME,
STOP TIME and START DATE you entered
for the lowest program number at four-second
intervals. Then the display changes to the next
higher program number, and so on until all
program information has been displayed.
3. Press 5 again if you wanl to view the next infor-
mation without waiting four seconds.
4. When you are finished, press PROGRAM to
return to the clock display.
Turn off the VCR. (See "Programming Reminders'"
on page 26.)
-Clearing a Timer Program
1. Press PROGRAM on the remote hand unit to
display the programming menu.
2. Press 5 (Program Review).
The display will show the START TIME,
STOP TIME and START DATE you entered
for the lowest program number at four-second
intervals. Then the display changes to the next
higher program number, and so on until all
program information has been displayed.
3. Press 5 again if you want to view the next infor-
mation withoul waiting four seconds.
4. Press CLEAR when the program information
you want to clear is displayed.
Notes:
Normal timer programs clear automatically when
the recording is finished, but daily and weekly
programs remain in the timer indefinitely.
All programs are erased if power is interrupted for
more than approximately ten minutes.
25