Filter
Top Products
Black and White Monitor
+
VCR, Color Monitor
+
VCR
Ridge Tool Company 7
Figure 7 – Ground Fault Circuit Interrupter (GFCI)
3. Unwrap the SeeSnake systems cable from its storage
hooks on the SeeSnake or Mini-SeeSnake frame.
(Figure 8)
NOTE! Never twist the connector body or you may dam-
age its pins. Twist only the locking sleeve.
4. Plug the systems cable into the mating connector on
the Monitor
+
VCR power supply (connector for
SeeSnake Systems Cable). Orient the systems cable
male connector by locating the “TOP” label and adjust
in UPWARD position (Figure 9). Make sure the guide
pin on the systems cable is properly aligned into the
guide socket on Monitor
+
VCR’s connector. This guide
pin is on the top of the connector. When joining
these connectors, make sure you push straight in until
fully seated and then screw down the locking sleeve.
Figure 10 shows a close-up of the joining connectors.
Figure 11 shows connector functions.
Figure 8 – SeeSnake Systems Cable
Figure 5 – Completely Closing the Top Door
NOTE! The lower door must be closed before the top door
is closed.
Operation
Powering the System
1. Locate the power cord on the back of the unit. Unhook
the Velcro strap and remove the plug from the holder.
(Figure 6)
NOTE! The outlet inside the cord wrap is not an active
plug. It is the holder for the GFCI plug.
Figure 6 – Power Cord and Cord Wrap
2. Plug the Monitor
+
VCR’s power cord into an approved
outlet. Press the reset button on the GFCI. (Figure 7)
NOTE! You must press the reset button every time you
plug the unit in.
Press Reset
Button
for Power
SeeSnake
System Cable