Filter
Top Products
CONNECTING MAINS POWER
Please refer to the rear panel view on page 5.The moulded IEC connector of the supplied mains lead should be
plugged into the socket (9) on the rear of the unit first and then plugged into the mains supply. The Mains power
switch (11) is on the rear panel of the DVD Player. This switch is normally left on. If the unit is likely to be
unattended for a long period, switch it off and unplug the mains lead from the wall.
SIGNAL CONNECTIONS
ANALOGUE OUTPUT:
The Analogue Output (2) uses RCA Phono sockets and should be connected to the
DVD or LINE input of your Preamplifier, Inegrated Amplifier or Audio Input of your TV.
The connection is: Right Channel – Red; Left Channel – White or Black.
DIGITAL OUTPUTS:
There are two Digital Outputs, one Coaxial the other Optical. The Digital Output (1)
uses a 75 Ohm RCA socket and should be connected to the Coaxial Digital Input of
your DSP.
The Digital Output (5) is an Optical Tos-Link and should be connected to the Optical
Tos-Link Digital Input of your DSP.
SCART OUTPUT:
There is a SCART Output (4) for convenience that could be connected to the SCART
Input of your TV, Projector or Monitor.
VIDEO OUTPUTS:
There are three Video Outputs, one Composite, one S-Video and one Component.
The Composite Output (3) uses RCA socket and should be connected to the
Composite Video Input of your TV, Projector or Monitor.
The S-Video Output (7) is a better Video link (remember to use high quality S-Video
cable and no longer than 3 metres) and should be connected to the S-Video Input of
your TV, Projector or Monitor.
For best quality picture the Component Video Output (6) uses 3 RCA connectors and
should be connected to the Component Video Input of your Projector or Monitor.
IMPORTANT NOTE: For optimum performance it is recommended to use high quality inter-connect cables such
as ROKSAN HDC-02A High Definition Analogue Cable and HDC-01D High Definition Digital Cable. The HDC-
01D terminated with Roksan RCA plugs can be used for Composite or Component links.
SETUP C a s p i a n Dual Laser DVD Playe
r
Remember The digital output is muted unless in General Setup Menu menu, ‘SPDIF’ is selected to be
‘ON’. The Stereo L&R output is on all the time.
Only with SPDIF output is selected to ON can your DSP decode 5.1-Channel information.
Roksan Audio ltd Caspian DVD Player User Manual
CLASSIFICATION: General Use Version 2.01
All specifications are liable to change without notice. E&OE Page 6 of 22 ENGLISH