Roland TU-400 Universal Remote User Manual


 
3
Installation of the control box for the
TU is a task which must be carried
out by two or more persons.
Injury may result if attempted by one person
without assistance.
To secure the part in place, use the
bolt included with the unit.
A loose bolt or use of other than the
specified bolt may result in the falling of the
part, leading to injury.
Roll material must be placed at a
predetermined shaft position.
Failure to do so
may allow the
material to fall,
leading to injury.
Removal of taken-up roll material
from the TU is a task which must be
carried out by two or more persons.
Injury may result if
attempted by one
person without
assistance.
When not in use for extended
periods, unplug the power cord from
the electrical outlet.
Failure to do so may
result in danger of
shock, electrocution,
or fire due to
deterioration of the
electrical insulation.
Do not use with a damaged power
cord or a power outlet that is loose
when the AC adapter is plugged in.
Use with any other power supply may lead
to fire or electrocution.
* For detailed information on loading material,
please refer to the CJ/FJ user's manual.
Do not attempt to change a roll
material while the power remains
switched on.
The take-up motor may be activated
unexpectedly while changing the roll,
leading to injury. The power must be
switched off before attempting to change
the material.
Do not allow the hands or hair to
touch the paper tube, flange, or
sheet during take-up.
The hands or hair may become caught.