Filter
Top Products
9
5. Adjusting the Sensor's Position
Turn on the power. Two LEDs
(green and red) light up.
1
Loosen the screw as shown in the
figure, and adjust the angle of the
sensor so that it is aligned with
the mirror.
2
Tighten the adjustment screw
securely at the angle where the
red LED has gone dark.
3
Red LED
Green LED
Screw
LED goes dark
AUTO
Material is taken up automatically
when material has been fed into the
sensor's detection area.
BACKWARD
FORWARD
Material take-up is in
the direction shown at
right.
Material take-up is in
the direction shown at
right.
Sensor detection area
The TU performs material take-up when
material is fed into this area.
Sensor
Mirror
Stand
CJ/FJ
Rear
Front
Power switch
OFF
No material take-up occurs, even when
material has been fed into the sensor's
detection area.
MANUAL
The material is taken up manually.
4. Operation Panel