Filter
Top Products
7
Introduction
The RKP-200 Keypad and RHB-200 Connecting
Hub provide an integrated system that allows con-
trol of Rotel multi-zone systems from wall mounted
keypads in remote zones.
Key Features
• Programmed to operate Rotel multi-zone receiv-
ers, DVD players, CD players, and AM/FM
tuners.
• Learning function to teach the RKP-200 com-
mands from other remotes. Multi-step SMART
programming for automatic sequences.
• System allows control from up to four zones.
• Two identically programmed keypads can be
installed in each zone.
• Built-in IR sensor allows each keypad to receive
commands from a handheld remote.
• Backlighting for use in dark rooms whenever
a button is pressed.
• Durable laser-etched buttons with permanent
labels. Optional buttons provide alternate la-
bels.
• Cloning feature for easy duplication of the entire
command set from one RKP-200 to another.
RKP-200 Overview
The following describes the features and connec-
tions on the RKP-200 keypad.
Device Buttons
Four buttons at the top of the keypad are perma-
nently configured as device buttons. Pressing a de-
vice button selects the active source input on the
multi-zone receiver and changes the function of the
command buttons to operate that component.
Command Buttons
Eight buttons at the bottom of the keypad are per-
manently configured as command buttons. Pressing
a command button sends an IR signal to operate
the selected component.
Multi-function Buttons
These two buttons are factory programmed as com-
mand buttons. However, they can be optionally
reconfigured as device buttons should your system
have more than four source components.
IR Sensor
An infrared sensor located behind the dark oval
lens at the top of the keypad, receives IR commands
from a handheld remote control.
Output Connector
A modular RJ-45 jack on the back of the keypad
connects the first keypad in a zone to the RHB-200
hub with CAT-5 Ethernet-style cables. Also, used to
connect the second keypad in a zone to the first.
Input Connector
A modular RJ-45 jack on the back of the keypad
for connecting a second keypad in a zone.
DIP Switches
Ten miniature switches, visible when the keypad
is removed from the wall, are used in configuring
the keypad.
RESET Button
A small button, visible when the keypad is removed
from the wall, cancels all learned commands and
restores the factory configuration.
RHB-200 Overview
The following provides a brief description of the
features and connections on the RHB-200.
Zone LEDs
Four LEDs on the front panel provide status infor-
mation during cloning of keypads.
Power LED
LED near right side of front panel illuminates when
the RHB-200 is connected to AC power.
Clone Button
Large button at right of front panel. Press to begin
cloning during configuration.