Filter
Top Products
Operation
46 Runco PL-43DHD and PL-50DHD Owner’s Operating Manual
PRE
L
IMINAR
Y
System Reset: To reset ALL DHD Controller settings (including image settings) back to
their factory defaults, choose System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, click Back to cancel.
Restore Saved Settings: Following a System Reset, select Restore Saved Settings to
apply all previously-saved settings to the PlasmaWall and DHD Controller.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save ALL settings, including “Custom” ISF
Presets (
page 40), ISF Day/Night presets (page 40), Output Shift
settings (page 42), Input Names (page 43) and Trigger settings
(page 45).
Caution