Filter
Top Products
MENU DESCRIPTION AND NAVIGATION
When the MENU button is pressed on either the remote control or the front panel, the main menu will appear
on-screen. An example of the main menu is shown to the right. The UP and DOWN buttons on the front panel,
and IR Remote Control will move the selected item on the menu.
Opening Screen
• Press ENTER to access the Input Source selection menu
• Press ENTER to access the Aspect Ratio selection menu
• Press ENTER to access the Picture setting menu
• Press ENTER to access the Input Position setting menu
• Press ENTER to access the ISF and Custom Presets menu
• Press ENTER to view information about the controller
The active source is indicated by an arrow to the left of the source; note that in the example to the right,
Composite is the current source.
Input Source
Indicates selection has been made for the Input Source selection menu
• Press ENTER to select the Composite input
• Press ENTER to select the S-Video 1 input
• Press ENTER to select the S-Video 2 input
• Press ENTER to select the Component SD input
• Press ENTER to select the HD/RGB 1 input
• Press ENTER to select the HD/RGB 2 input
• Press ENTER to select the DVI 1 input
• Press ENTER to select the DVI 2 input
• Press ENTER to select the HD Pass Thru 1 input
• Press ENTER to select the HD Pass Thru 2 input
If pass-through is selected, note that no on-screen menus will be displayed since the signal is simply being
‘looped’ directly through the analog output. When pass-through is the selected source, pressing MENU will
not automatically select the last selected input before Pass-through was selected. If you wish to choose another
source, Runco recommends using the direct access buttons to select the desired source as opposed to pressing
MENU. Pass-through is not available when the DVI output is in use.
Runco Video
Input Source
Aspect Ratio
Picture
Input Position
ISF Presets
Information
Input Source
Composite
S Video 1
S Video 2
Component SD
HD/RGB 1
HD/RGB 2
DVI 1
DVI 2
HD Pass Thru 1
HD Pass Thru 2
To select a source via the main menu, press either the up or down buttons on
the remote or front panel and highlight the desired source, and press ENTER.
Otherwise, you may select a source by pressing either the left or right arrow buttons
(on the remote or front panel) when no menus are on-screen, or by pressing one of
the direct access buttons on the remote control (recommended).
NOTE: If DVI input is used with HDCP content, RGBHV output is
automatically disabled. This is in compliance with HDCP regulations.
17