Filter
Top Products
QUICK SETUP GUIDE
12
Step I
Connection:
1. Connect Power to Both Projector and DHD controller
2. Connect DVI output from the DHD to projector DVI in
3. Connect Video (Composite), S-Video to1 or 2, Component 480i (RCA) input, HD signals to HD1 or HD2 (BNC), DVI
4. Turn ON the system from the DHD controller or use the DHD remote.
Step II
From the Projector:
1. Press Menu to select Main window. Use the Up or Down arrow to select Lens Adj.
2. Adjust Lens shift, Zoom, and Focus for desired screen size.
3. Press Menu to go back to Main window and select Preference for Picture Orientation.
4. Select for projector mount configuration (Floor Front, Ceiling Front, Floor Rear, or Ceiling Rear)
Step III
Calibration and Setup:
1. Make sure you have picture on the screen from all connected sources.
Note: The system must be setup first by using S-Video or Component 480i (RCA input) preferably Component 480i
first.
2. Select Component SD from the DHD controller.
3. Using a test disc and select the Pluge pattern for Brightness and 10-step gray scale for Contrast
4. From the DHD controller, select Calibration, press Enter and under ISF Night select Input Image.
5. Adjust for correct Brightness and Contrast.
6. Select 80 IRE from test disc.
Go to projector.
7. Press Menu to select Main window. From Main window select Image and press Enter.
8. Select Contrast and press Enter.
Under Contrast you have Red, Green, and Blue selection.
9. Use the Up and Down arrow to select Green or Blue and press Enter. The cursor will blink from the selected color. Use
the UP or Down arrow to adjust. Pres Enter when done to store the number.
Note: Decrease the value to set for desired temperature.
10. Select 20 or 30 IRE window for low-end adjustment
11. Select Brightness and adjust RED, Green, or Blue for D6500. Note: Decrease the value to set for D6500.
12. Select color bar from test disc.
13. From the DHD controller select Calibration, press Enter and under ISF Night select Input Image and select Color and
press Enter
14. Use the Blue Filter (required) and adjust for correct color setting.
* From this point on, the Projector should not be touched and all other adjustments for other sources must be done
at the DHD Controller.
15. For other NTSC sources, select Calibration, press Enter. Under ISF Night, select Input Image and adjust for correct
Brightness, Contrast, Color, Tint, and sharpness.
Step IV
HD and DVI Setup:
From DHD controller
1. For HD input and DVI, select Calibration press Enter and under ISF Night select Input Image for video adjustments.
2. Select Input Color for white balance adjustments.
Follow the steps below ensure proper installation of the VX-2c projector and DHD Controller.