Filter
Top Products
Installation
16 PlasmaWall XP Series Installation/Operation Manual
PRE
L
IMINAR
Y
• Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
plasma display away from the fluorescent lamp.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the plasma display.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the plasma display and repeat the operation.
3.2
Quick Setup
Table 3-1 gives a quick overview of the PlasmaWall installation process. The sections
following this one provide detailed instructions.
The signal from the remote control can be reflected by walls or
other surfaces.
Note
Installation must be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, refer to
page...
1 Mount the PlasmaWall on a wall, table stand or floor ped-
estal
17
2 Connect the DHD Controller to the PlasmaWall 22
3 Connect signal sources to the DHD Controller 24
4 Connect external controller to DHD Controller RS-232 port
(optional)
29
5 Apply power to the PlasmaWall 33
6 If using the PlasmaWall with a computer, adjust computer
display properties
33
7 Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
36
Note