Filter
Top Products
7
Master Auxiliary Send Section
Each of the L Series AUX buses and the EFX bus have a
master control knob, which is used to adjust the overall
level of that AUX bus output.
24 - AUX 1 Master Send
The Aux 1 signals from mono and stereo input chan-
nels, along with the DSP returns are mixed together
and sent to the AUX 1 Output. Use the AUX 1 level
controls to set the amount of signal being sent to
Aux 1 Output.
Controls and Functions
24BIT DIGITAL EFFECT SECTION - continued
22 – TO AUX 2 - Effects Return Control
The TO AUX 2 control is used to adjust the level of the
effects from the built-in digital Multi-effect being that’s
being sent to the AUX 2 monitor bus. This allows you
to add the DSP effects to the signal in your monitor
speakers. Turn this knob up if you want to hear the effect
in the AUX 2 monitor mix.
23 - TO AUX 1 - Effects Return to Aux 1 control knob
The TO AUX 1 control is used to adjust the level of the
effects from the built-in digital Multi-effect that’s being
sent to the AUX 1 monitor bus. This allows you to add the
DSP effects to the signal in your monitor speakers. Turn
this knob up if you want to hear the effect in the AUX 1
monitor mix.
25 - AUX 2 Master Send
The Aux 2 signals from mono and stereo input chan-
nels, along with the DSP returns are mixed together
and sent to the AUX 2 Output. Use the AUX 2 level
controls to set the amount of signal being sent to
Aux 2 Output.
26 - AUX 3 Master Send
The Aux 3 signals from mono and stereo input chan-
nels, along with the DSP returns are mixed together
and sent to the AUX 3 Output. Use the AUX 3 level
controls to set the amount of signal being sent to
Aux 3 Output.
27 - EFX Master Send
The EFX signals from mono and stereo input chan-
nels, along with the DSP returns are mixed together
and sent to the internal DSP and the EFX Output.
Use the EFX level controls to set the amount of sig-
nal being sent to the internal DSP and the EFX Send
jack.
28 - STEREO RETURN – control knob
The L Series feature an additional STEREO RETURN input
that can be used to return the outputs of the an external
effects processor, or to connect the output of any stereo
line level device to the main mix
29 -CD/TAPE – control
The L1200 and L2000 have a dedicated line level CD/TAPE
LEVEL input to connect a CD, Tape or MP3 player. The
CD/TAPE Level control is used to adjust the volume of the
signal connected to the CD/TAPE input.
30-MUTE CHANNELS – switch
You can turn all the Mic/Line channels with a press of a
single button using the MUTE CHANNELS switch. This is
especially convenient when you take a break and want to
leave all the levels set so they are ready when you begin
to use your PA system again. The MUTE CHANNELS does
not turn off the stereo channels, and does not turn off the
CD/TAPE inputs. So, when the MUTE CHANNELS switch is
on, you still have stereo returns for a CD or MP3 player.
24
25
26
27
28 29 30