Filter
Top Products
10
MAIN Output Section
49 - SOLO (AFL MAIN MIX) – switch
The MAIN MIX output’s AFL, or After Fader Listen
switch allows you to listen to, or “solo”, the MAIN MIX
in the headphones. When the MAIN MIX Solo switch
is pressed down, the left/right mix will be heard in
headphones plugged in to the PHONES connector
located in the top panel jack field. This allows you
to listen to the stereo mix , (let’s say), to check that
a signal is not distorted before it gets to the power
amplifier. Since the signal is sent after the MAIN MIX
level fader, you hear the signal with the added gain
from the MAIN MIX Level control. This switch also
allows you to view the Main Mix levels on the VU
meters.
50 - MAIN MIX (left and right) - Level fader
The MAIN MIX Level fader adjusts the level of MAIN
left and right stereo mix.
Controls and Functions
46 – TO MAIN LEFT– switch
The TO MAIN LEFT switch is used to assign the
GROUP to the left channel of the MAIN stereo mix. If
you want to send the GROUP mix to the stereo mix
press the TO MAIN LEFT switch down.
47 – TO MAIN RIGHT– switch
The TO MAIN RIGHT switch is used to assign the
GROUP to the right channel of the MAIN stereo mix.
If you want to send the GROUP mix to the stereo mix
press the TO MAIN RIGHT switch down.
48 – Group Level - fader control
The Group level fader is used to control the overall
level of the GROUP mix.
Assigning Channels to Group Outputs
If you want to control a number of channels with
one fader you can create a mix subgroup by using
the channel GROUP assign switches. In many appli-
cations when assigning a channel to a group, you do
not want it assigned to the MAIN mix, so be sure the
MAIN assign switch is up.
Mono Group Sends - Odd Even Panning
To create one or more mono subgroup mixes, it is
important to pay attention to the PAN knob. By using
the channel PAN knobs, you can create four mono
sub mixes.
If you want to send a group of channels to Group 1,
press the Group 1-2 assign switch down and set the
PAN knob all the way to left on those channels.
If you want to send a group of channels to Group 2,
press the Group 1-2 assign switch down and set the
PAN knob all the way to right on those channels.
If you want to send a group of channels to Group 3,
press the Group 3-4 assign switch down and set the
PAN knob all the way to left on those channels.
If you want to send a group of channels to Group 4,
press the Group 3-4 assign switch down and set the
PAN knob all the way to right on those channels.
Stereo Group Sends
You can build a stereo sub group mix using two
group outputs. To do this using Groups 1 and 2, en-
gage the TO MAIN LEFT switch on GROUP 1 for the
left channel and engage the TO MAIN RIGHT switch
on GROUP 2 for the right channel. Since the GROUP
outputs follow the channel PAN knob, the stereo mix
will present at the GROUP 1 and 2 outputs.
50
49