Filter
Top Products
12
Master Input and Output Section
The L1200 and L2000 mixer's Master Input and
Output section has the connectors for interfacing
the FOOTSWITCH, MAIN OUT, MAIN 2 OUT, MAIN
INSERT POINTS, GROUP OUTS, GROUP INSERT
POINTS, and the AUX Send’s.
6 - AUX SEND (1 through 3) - 1/4-inch jacks
The signals present at the AUX outputs are sent from
the AUX bus 1, 2 and 3, which are fed from the input
channels’ AUX 1, 2 and 3 control knobs. In a live
sound situation, AUX 1, 2 and 3 are normally used to
create three individual monitor mixes by connecting
the AUX output to a power amp and monitor
speaker. TS phone jack connector pin-out - Sleeve:
Ground, Tip: Hot (+).
7 - EFX SEND - 1/4-inch jack
The EFX SEND output is used to send a signal to
an external signal processor such as a delay or
reverb. The signal present at the EFX SEND output
is sent from the EFX bus, which is fed from the
input channels’ EFX control knob. TRS phone jack
connector pin-out - Sleeve: Ground, Tip: Hot (+),
Ring: Cold (-)
10
8
11
9
8 - CD/TAPE Inputs - RCA jacks
The L Series mixers feature a stereo line level input
on RCA connectors for connecting the output of
devices such as MP3, CD, computer soundcard,
cassette player, or any other line level device. These
are controlled by the CD/Tape level control.
9 - Record Out - RCA jacks
The signal present at this connector is the MAIN bus
signal before it has passed through the MASTER
level control. The nominal output level is -10dBV and
the impedance is 100 Ohms.
10 – STEREO RETURN
The L1200 and L2000 have one pair of 1/4-inch jacks
for connecting stereo line level sources like those
from the outputs of effects processors. The LINE
inputs have a nominal operating level of -40dBV
through - 10dBV. TRS phone jack connector pin-out
- Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
11 - MAIN 2 OUT - 1/4-inch jacks
In a live sound application, you can drive a second
speaker system using the MAIN 2 OUT outputs con-
nected to a power amplifier or powered speakers. In
a recording application, the MAIN 2 OUT outputs are
used to connect to a stereo device such as computer
sound card, MP3, or cassette recorder. The signal at
the MAIN 2 OUT jacks follows the MAIN 2 level con-
trol knob allowing you to set a different level to the
recorder. TR phone jack connector pin-out - Sleeve:
Ground, Tip: Hot (+).
12 - GROUP OUT - 1/4" jacks
In a live sound application, you can connect
additional zone speaker systems using GROUP OUT
outputs connected to a power amplifier or powered
speakers. The signal at the GROUP OUT jacks follows
the GROUP volume fader.TRS phone jack connector
pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
L1200 and L2000 Input and Output Connections
1213
7
6