Filter
Top Products
20 - English
Connecting
Connecting to an Audio System
(2 Channel Amplifier)
1. Using the audio cables, connect the AUDIO (red and
white) OUT terminals on the rear of the Blu-ray disc
player to the AUDIO (red and white) IN terminals of
your Amplifier.
2. Using the video signal cable(s), connect the HDMI OUT,
COMPONENT, S-VIDEO, or VIDEO terminals on the
rear of the Blu-ray disc player to the HDMI IN,
COMPONENT, S-VIDEO, or VIDEO terminal of your
TV as described on pages 17 to 20.
3.Turn on the Blu-ray disc player, TV and Amplifier.
4. Press the input select button of the Amplifier to select
the external input in order to hear sound from the
Blu-ray disc player. Refer to your Amplifier's user
manual to set the Amplifier's audio input.
LAN
RED
WHITE
RED WHITE
2-Channel stereo amp
Audio Cable
Manufactured under license from Dolby
Laboratories. “Dolby” and the double-D symbol
are trademarks of Dolby Laboratories.
“DTS” and “DTS Digital Surround” are
registered trademarks of DTS, Inc.
Connecting to a TV(Video)
1.
Using video/audio cables, connect the VIDEO
(yellow)/AUDIO (red and white) OUT terminals on the rear
of the Blu-ray disc player to the VIDEO (yellow) /AUDIO
(red and white) IN terminals of your TV.
2. Turn on the Blu-ray disc player and TV.
3.
Press the OUTPUT SELECT button on the front panel
of the unit until the VIDEO indicator lights. Make sure
the unit is in Stop mode.
4. Press the input selector on your TV remote control
until the Video signal from the Blu-ray disc player
appears on the TV screen.
• If you have set the remote control to properly operate
with your TV (pages 14~15), press the TV INPUT SEL.
button on the remote control and select VIDEO as the
external source of the TV.
■
Noise may be generated if the audio cable
placed too close to the power cable.
■
If you want to connect to an Amplifier,
please refer to the Amplifier connection
page. (See pages 20~22)
■
The number and position of terminals may
vary depending on your TV set. Please refer
to the user's manual of your TV.
■
If there is one audio input terminal on the TV,
connect it to the [AUDIO OUT][left] (white)
terminal of the Blu-ray disc player.
■
If you set the OUTPUT SELECT to HDMI,
the Video/S-Video and Component Out
terminals will not output any signal.
NOTE
LAN
P1200_XAC_ENG_1~36 3/7/70 11:13 AM Page 20