Filter
Top Products
GB-39
DCB-H360R
GB
GB-38
DIGITAL CABLE RECEIVER
DCB-H360R
TECHNICAL SPECIFICATIONS
Power supply
Type : SMPS
Input voltage : AC 100-240V~, 50/60 Hz
Fuse rating : 250 V/T1.6AH
Tuner & Demodulator
Input Frequency : 50.5~858 MHz
Channel Bandwith 8 MHz
DEMODULATION : QAM DVB-C
SYMBOL RATE : MAX 7.252 Msps
Constellation : 16, 32, 64, 128, 256 QAM
CABLE OUT : RF LOOP-THROUGH OUTPUT for other
receiver or TV
Video decoder
System decoding : MPEG-2 ISO/IEC 13818-2
Profile@Level (MP@HL(HD), MP@ML(SD))
H.264 ISO/IEC 14496-10
(MP@L3, MP@L4, HP@L4 up to 30 Mbps)
Resolution : 1080i, 720p, 576p, (576i)
Video Output: SD output (2 SCART (AV1,AV2), Composite RCA)
HD output (Component (YP
B
P
R
), HDMI)
Video Format 4:3(Normal) & 16:9 (Widescreen)
Audio Decoder
System decoding : MPEG Audio-1 ISO/IEC 11172-3
(Layer1, Layer2)
MPEG Audio-2 ISO/IEC 13818-3
Dolby Digital (AC-3)
Audio mode : Mono, Dual stereo, Joint stereo
Sampling Rate: 32kHz, 44.1kHz, 48kHz, 96kHz
Audio output : Analog output (L/R (RCA) 1 CH)
Digital output (S/PDIF(Optical))
PHISICAL SPECIFICATION
Size (W x D x H) 351 x 227 x 60 mm
Weight (Net) 2.47Kg
Problem Possible cause Solution of the problem
No display LED on Power cord not plugged in correctly Power cord plug in correctly
the front panel;
No power supply
No pictures on the screen Receiver in Standby mode; Set receiver to “On”;
SCART,RCA or HDMI not connected Check connection;
tightly to video input of television;
Incorrect channel or video output Check channel and video input of TV
selected on television: (TV instruction manual);
Incorrect video output selection on HD Check video output on HD receiver
Receiver (Refer to page 10)
No sound SCART or Audio connected incorrectly; Check connection;
Loudness level = 0; Increase loudness on television set
or HD receiver;
Muting active Press the MUTE key
Remote Control does not Incorrect Operation; Point remote control towards the
operate directly receiver;
Batteries dead or inserted incorrectly Replace batteries or insert correctly
Poor picture quality Signal strength too low Check all wire connections
Menu screen does not Channel lists not installed; Scan channels. Please go to
disappear Installation menu;
On-Screen Error Messages; Signal cable not connected or not tight Check connection
“Searching for signal”;
“No signal”
On-Screen Error Messages; Smartcard (Depend on model)
“Smartcard Failure” - not plugged in correctly; Check the smartcard;
“Unknown smartcard”
“Please insert Smartcard” - not plugged in Insert the smartcard
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed of
with household refuse. Please obtain appropriate information about the regulations in your
community, and dispose of all refuse in accordance with regulations at the separate locations
provided.
DISPOSAL
TROUBLESHOOTING
DCB_H360R draft 0604 eng 06/4/06 07:39 Page 38