Filter
Top Products
124
Channel
6
6 Channel
6.2 Auto Program
The Auto Program function memorizes all channels that are available over the air or through your cable
system and adds them to the Channel List.
To start Auto Program, follow these steps:
1 Push MENU [] Channel Auto Program ENTER
[ ]
on your remote. The Antenna
Source screen appears.
2 On the Antenna Source screen, select the source of your product signal.
Air: If your product is connected to an antenna choose Air, and then press ENTER
[ ]
. The
product will automatically start memorizing channels.
Cable: If your product is connected to a cable outlet, choose Cable, and then press ENTER
[]
. Go to Step 3.
3 On the cable type screen, use the / / / buttons to select the type of digital and analog cable
systems you have: STD, HRC, or IRC. Most systems are STD (Standard). When done, select Next,
and then press ENTER
[ ]
. The product will start memorizing channels.
Channel memorization can take up to 45 minutes, depending on your cable system.
Memorized channels are added to the Added Channels list. These are the channels you will
see when you use the channel buttons on your remote.
6.3 Clear Scrambled Channel
MENU
[] Channel Clear Scrambled Channel ENTER
[ ]
(digital channels only)
This function filters out scrambled channels after Auto Program is completed. This process may take up
to 20~30 minutes.
How to Stop the Clear Scrambled Channels function
1 Press the [ ] button to select Stop.
2 Press the [ ] button to select Yes.
3 Press the [ ] button.
This function is only available in Cable mode.
m
m