Samsung DVD Recorder DVD Recorder User Manual


 
Step Getting Connected
Step Setup
Step Basic Operation
Quick Setup Guide
Step
Step Getting Connected
Select one of the following three types of connections:
Antenna + DVD Recorder + TV : No Cable Box
Antenna + Set-Top Box or VCR + DVD Recorder + TV : No Cable Box
Antenna + Cable Box + DVD Recorder + TV
Antenna + DVD Recorder + TV : No Cable Box
Connect the signal source to the DVD
Recorder
Use a TV antenna or coaxial cable to connect the signal
source coming from the antenna or wall to the VHF/UHF
RF-IN jack on the DVD Recorder.
Connect the DVD Recorder to the TV
Use the supplied RF cable to connect RF-OUT on the
DVD Recorder to the ANT jack on the TV. Then use the
Video/Audio Cable to connect ANALOG AUDIO
OUT(R/L)/VIDEO OUT jacks on the DVD Recorder to the
Audio & Video jacks on the TV.
For better picture quality, if your TV has an S-Video
jack, you can use S-Video cable instead of the yellow
video connector on the Video/Audio cable.
For the best picture quality, if your TV has
Component video jacks, you can use component
cables instead of the yellow video connector on the
Video/Audio cable. Set the Component video out
select switch on the back of your DVD recorder to
480p/480i video output mode. If your TV supports
progressive scan, select 480p.
If you have an AV amplifier
Connect either audio cables from the ANALOG AUDIO OUT
jacks on the DVD Recorder to the LINE IN jacks on your AV
amplifier, or a digital cable from the DIGITAL AUDIO OUT
(COAXIAL or OPTICAL) jack on the DVD Recorder to the
DIGITAL AUDIO IN jack on your AV amplifier.
The VHF/UHF RF OUT jack of this product sends only signals received through the antenna. It does not output audio/video signals.
You must use one of the following connections on this unit.
1
This Recorder will only record on
DVD-R, DVD-RW and DVD-RAM discs.
C Samsung Electronics Printed in Korea