Filter
Top Products
OPERATION
26
Selecting the Video Signal Source
Before your TV can begin memorizing the available channels, you must specify the type of
signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button.
Press the … or † button to
select “Channel”, then press the
ENTER button.
2
Press the … or † button to
select “Air/CATV”, then press the
ENTER button.
Press the … or † button to
select “Air”, “STD”, “HRC” or
“IRC”, then press the ENTER
button.
Press the EXIT button to exit.
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and
cable channels. After the available channels are memorized, use the CH and CH buttons
to scan through the channels. This eliminates the need to change channels by entering the
channel digits.
œ If you are connected to an
antenna, press the
… or † button
to select “Air”.
œ If you connected cable, press
the
… or † button to select the
type of cable system: “STD”,
“HRC” or “IRC”.
• “STD”, “HRC” and “IRC” identify various types of cable TV systems. Contact your local cable company
to identify the type of cable system that exists in your particular area. At this point the signal source
has been selected. Proceed to “Storing Channels in Memory”.
• Subscription cable services require service-specific requirement for viewing.
Antenna : Ant.1
√√
Air/CATV : Air
√√
Auto Program
√√
Favorite Channels
√√
Fine Tune
√√
Add/Delete
√√
† More
Move Enter Return
Channel
T V
Antenna : Ant.1
√√
Air/CATV : Air
√√
Auto Program
√√
Favorite Channels
√√
Fine Tune
√√
Add/Delete
√√
† More
Move Enter Return
Channel
T V
Air
STD
HRC
IRC
BP68-00289A-02Eng 7/21/04 10:01 AM Page 26