Filter
Top Products
2CHAPTER TWO: INSTALLATION 2.8
Connecting a DTV Set-Top Box (480p, 1080i)
When switching to the DTV mode, either 480p or 1080i format is automatically selected
according to the input signal.
Note: Only 480p and 1080i formats are supported.
1
Connect a set of audio cables between
the DTV Set-Top Box audio in jacks on
the TV and the AUDIO OUT jacks on the
DTV Set-Top box.
2
To enable Component video viewing,
connect video cables between the Y, P
B
,
and P
R
inputs on the TV and Y, P
B
, and P
R
(or Y, C
B
, C
R
) outputs on the DTV Set-Top
box.
Note: For an explanation of
Component video, see your DTV Set-
top box’s owner’s instruction.
Connecting Surround Speakers
(HCL552W/HCL652W/HCL473W/HCM553W/HCM653W only)
1
Connect inputs of an amplifier to the
SURROUND OUT outputs of the TV.
Then connect the surround speakers to
your amp.
INSTALLATION
Note: This figure shows the Standard Connector-jack panel. The actual configuration on your TV may
be different, depending on the model.
01509D(E)-CHAPTER 2 2004/10/19 09:18 AM Page 8