Filter
Top Products
80
PDP (Continued)
Problem
Possible Solution
There is no signal in a digital chan-
nel, and messages “Searching for
Signals” followed by “No Signal”
appear.
Cause: Channels have been stored
using Auto Memorize but the
broadcasting companies are not
sending the corresponding signals.
Or External Input has been selected
but there is no signal.
Solution: Select an alternative channel or switch the
external input source.
The message “Not supported sound
format” appears.
Cause: Digital Audio rather than
AC-3 (such as DTS, MPEG-1 or
MPEG-2) was entered for Audio
when SPDIF Input is selected in the
Component Mode resulting in
displaying this message with no
picture.
Solution: AV Center cannot handle the Audio Mode
except AC-3. Switch the input to AC-3, or alternatively
select Set-Up in the Menu, move to Sound In/Out then
switch Digital Input to Lt/Rt.
Note: Digital Audio inputs except AC-3 might cause a
severe damage to the system. Please use Dolby Digital
as a digital audio input.
The picture quality is poor in the
Component Mode despite setting
480p.
Cause: To enable the wireless signal
transmission for 480p input, it is
converted to 480i before MPEG
Encoding.
Solution: MPEG Encoding of 480p is not possible in
the current consumer electronics technology as it is,
so viewing the original 480p picture quality is limited.
After selecting the STB Mode of the
Remote Control, AV Center does not
respond to the Remote Control.
Cause: The Remote Control of AV
Center only turns power ON and
OFF, but cannot respond to other
Remote Control keys.
Solution: Set the Remote Control to the TV Mode and
perform all controls on the PDP.
The message “Not available in the
current mode.” appears.
Cause: Input of unavailable function
keys (e.g. trying to switch a channel
in External Input mode) may cause
the message to appear.
Solution: Please try to use other menu keys that are
available.