Filter
Top Products
3
Press the ▲ or ▼ button to memorize the channels of
the selected connection.
Press the ENTER button to select “Start”.
Notes
• If the antenna is connected to ANT 1 IN (CABLE IN),
select “Cable” and if it is connected to ANT 2 IN
(AIR IN), select “Air”.
• If both ANT 1 IN and ANT 2 IN are connected,
select the “Air + Cable”.
4
Select the correct signal source (STD, HRC, and
IRC) by pressing the ▲ or ▼ button, then press
the ENTER button
.
Note
•
STD, HRC, and IRC identify various types of cable
TV systems. Contact your local cable company to
identify the type of cable system that exists in your
particular area. At this point the signal source has
been selected. Proceed to “Storing Channels in
Memory” on page 38.
5
The TV will begin memorizing all of the available
channels.
After all the available channels are stored, the Auto
program menu reappears.
Press the ENTER button at any time to interrupt the
memorization process.
Press the ENTER button to select OK when channel
memorization is complete.
“Set to daylight savings time.” menu is automatically
displayed.
33
Select the antennas to memorize.
Air
Cable
Air + Cable
Plug & Play
Enter Skip
Move
Start
Start
Start
Select the cable system.
STD
HRC
IRC
Plug & Play
Enter SkipMove
Plug & Play
Enter Skip
Auto Program in Progress.
Cable Channel 67
Stop
Plug & Play
Enter Skip
Auto Program is completed.
14 Channels were memorized.
AIR : 9 , Cable : 5.
OK
BN68-00825J-00Eng_(032~045) 5/18/05 2:09 PM Page 33