Filter
Top Products
11
TV : SCANNING AND SWITCHING BETWEEN ANYNET+ DEVICES
1 Press the TOOLS button.
• Press the or button to select “Device List”, then press the ENTER ( ) button.
• Anynet+ devices connected to the TV are listed.
• If you cannot nd a device you want, press the red button to scan for devices.
2 Press the or button to select "Media Center" and press the ENTER ( ) button. TV displays Windows Media Center.
Only when you set “Anynet+ (HDMI-CEC)” to On in the “Application” menu, the “Device List” menu appears.
• Switching to the selected devices may take up to 2 minutes. Once selected, the operation cannot be cancelled.
• The time required to scan for devices is determined by the number of connected devices.
• When the device scan is completed, the number of devices found is not displayed.
• The TV automatically scans devices when it is turned on. If you connect your Extender after the TV is on, select the Searching
Connections menu on the TV to search for devices.
• Connect the TV to the Extender and then turn on the TV. Press the GREEN BUTTON on the device's remote or the DMA button on the
TV’s remote control. Windows Media Center will be launched.
• If you switch to an input mode other than Anynet+, the Extender will be turned off after 5 minutes. Press the TOOLS button on the
TV’s remote control to start the Anynet+ device.
• If you turn off the TV, the Extender will be turned off.
■
TV menu operation.
Grandprix_new.indd 11 2008-07-08 오후 1:32:32