Filter
Top Products
37
Using "PCoIP"?
2
2 Using "PCoIP"?
z <Subnet Mask>
The <Subnet Mask> field is the device’s subnet mask. If DHCP is disabled, this field is required. If
DHCP is enabled, this field is not editable. This field must be a valid subnet mask, if an invalid subnet
mask is entered, the OSD will prompt the administrator to correct it.
z <Gateway>
The <Gateway> field is the device’s gateway IP address. If DHCP is disabled, this field is required. If
DHCP is enabled, this field is not editable.
z <Primary DNS Server>
The <Primary DNS Server> field is the device’s primary DNS IP address. This field is optional. If
DHCP is enabled, this field is not editable.
z <Secondary DNS Server>
The <Secondary DNS Server> field is the device’s secondary DNS IP address. This field is optional.
If DHCP is enabled, this field is not editable.
z <Domain Name>
The <Domain Name> is the domain name used, e.g. ‘domain.local’. This field is optional. This field
specifies the domain that the Host or Portal is on.
z <FQDN>
The <FQDN> is the Fully Qualified Domain Name for the Host or Portal. The default is pcoip-host-
MAC or pcoip-portal-MAC where MAC is the Host or Portal’s MAC address. If used, the Domain
Name will be appended, e.g. pcoip-host-MAC.domain.local.
z <Ethernet Mode>
The <Ethernet Mode> field configures the Ethernet mode of the Portal. The options are:
<Auto>
<100 Mbps Full-Duplex>
<10 Mbps Full-Duplex>
Administrators should always set the <Ethernet Mode> to <Auto> and only use <10 Mbps Full-
Duplex> or <100Mbps Full-Duplex> when the other network equipment, e.g. switch, is also
configured to operate at <10 Mbps Full-Duplex> or <100 Mbps Full-Duplex>.
<Label> Tab
The <Label> tab allows an administrator to add custom information for the Host or Portal.
The Portal Label parameters can also be configured using the Webpage Administration Interface.