Filter
Top Products
36
Using "PCoIP"?
2
2 Using "PCoIP"?
z <Language>
z <OSD>
z <Reset>
z <VMware View>
Each tab has <OK>, <Cancel>, and <Apply> buttons that allow the administrator to accept or cancel
the setting changes made on the tab.
Some PCoIP devices have password protection disabled and do not require a password to login into
the administration webpages or access the OSD parameters. Password protection for the Log In page
and OSD can be enabled through PCoIP Management Console.
<Network> Tab
The <Network> tab allows an administrator to set the Portal network parameters.
The Network parameters can also be configured using the Webpage Administration Interface.
Figure 2-4: <Network> Configuration
z <Enable DHCP>
When <Enable DHCP> is enabled, the device will contact a DHCP server to be assigned an IP
address, subnet mask, gateway IP address and DNS servers. When disabled, the device requires
these parameters to be set manually.
z <IP Address>
The IP Address field is the device’s <IP address>. If DHCP is disabled, this field is required. If DHCP
is enabled, this field is not editable. This field must be a valid IP address, and if an invalid IP address
is entered, the OSD will prompt the administrator to correct it.