Filter
Top Products
CHAPTER THREE: TV OPERATION 3.5
OPERATION
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH ▲ and
CH ▼ buttons to scan through the channels. This eliminates the need to change channels
by entering the channel digits. There are three steps for memorizing channels: selecting a
broadcast source, memorizing the channels (automatic) and adding and deleting channels
(manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the Menu button
to display the menu.
2
Press the CH ▼ button
twice to highlight
“CHANNEL.”
3
Press the VOL + button.
“ANT/CATV” will be
selected.
4
Repeatedly press the
VOL + button to cycle
through these choices:
ANT (antenna) STD,
HRC or IRC (all cable
TV).
Note: STD, HRC and IRC identify various types of cable TV
systems. Contact your local cable company to identify the type
of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to
“Storing Channels in Memory” (next page).
01066D(E)-CHAPTER 3 4/12/05 9:26 AM Page 5