Filter
Top Products
20
OPERATION
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CH and
CH buttons to scan through the channels. This eliminates the need to change
channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and delet-
ing channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1
Press the MENU button to
display the menu.
Press the
▲ or ▼ button
to select “Channel”, then
press the
ˇ
or
ˆ
button.
2
Repeatedly press the
ˇ
or
ˆ
button to cycle through
these choices:
ANT (antenna), STD, HRC
or IRC (all cable TV).
Press the EXIT button to
exit.
Note: STD, HRC and IRC identify various types of cable TV systems. Contact your local cable com-
pany to identify the type of cable system that exists in your particular area.
At this point the signal source has been selected. Proceed to “Storing Channels in Memory” (next
page).
ANT/CATV
ˇˇ
ANT
ˆˆ
Auto Program
ˆˆ
TV/AV
ˇˇ
TV
ˆˆ
Fine Tune
ˆˆ
Add/Erase
ˆˆ
Channel
Move Select Exit
ANT/CATV
ˇˇ
ANT
ˆˆ
Auto Program
ˆˆ
TV/AV
ˇˇ
TV
ˆˆ
Fine Tune
ˆˆ
Add/Erase
ˆˆ
Channel
Move Select Exit