Filter
Top Products
English - 18
INSTALLATION
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 14~17). Skip step 1 if you have not
yet connected to an antenna or a cable system.
1
Unplug the cable or antenna from the
back of the TV.
2
Connect the cable or antenna to the
ANTENNA IN terminal on the back of
the VCR.
3
Connect a coaxial cable between the
ANTENNA OUT terminal on the VCR
and the antenna terminal on the TV.
4
Connect a set of audio cables between
the AUDIO OUT jacks on the VCR and
the AUDIO jacks (AV1~AV3) on the TV.
If you have a “mono” (non-stereo) VCR,
use a Y-connector (not supplied) to
hook up to the left and right audio input
jacks of the TV. If your VCR is stereo,
you must connect two cables.
5
Connect a video cable between the
VIDEO OUT jack on the VCR and the
VIDEO jack (AV1~AV3) on the TV.
Follow the instructions in “Viewing an
External Signal Source” to view your
VCR tape.
Ferrite Core
The ferrite core is used to attenuate unde-
sired signals. When connecting cables,
attach the ferrite core to the cable near the
connector.
TV Rear Panel
TV Rear Panel
AA68-03263C-00_eng_Chapter2 3/11/05 5:39 PM Page 18