Filter
Top Products
INSTALLATION
English - 18
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna
or a cable TV system (according to the instructions on pages 14~17).
• Please be sure to match the color coded input terminals and cable jacks.
1
Connect a coaxial cable between the
“ANT 1 IN (Air)” terminal on the TV and
the antenna out terminal on the VCR.
A coaxial cable is usually included with
a VCR. (If not, check your local
electronics store).
2
Connect a set of audio cables between
the “AV IN 1 (L, R)” (or “AV IN 2/3 (L,
R)”) jacks on the TV and AUDIO OUT
jacks on the VCR.
If you have a mono VCR, connect
L(mono) to VCR audio out using only
one audio cable.
3
Connect a video or S-video cable
between the “AV IN 1 (VIDEO)” (“AV IN
2/3 (VIDEO)” or “S-VIDEO IN 1”) jack on
the TV and the VIDEO OUT jack on the
VCR.
Refer to your VCR’s instructions for
more information about how to view
your VCR tape.
TV Rear Panel
• Also, you can connect to “AV IN 4” on the side panel of TV.
1
2
3
AA68-03733C-00Eng 10/18/05 6:08 PM Page 18