Filter
Top Products
English - 32
OPERATION
Storing Channels in Memory
œ
Press the ENTER button at any
time to interrupt the memorization
process and return to the Channel
menu.
œ
Note: The TV must be connected to an
antenna in order to receive digital TV
signals.
Even if a particular channel is deleted
from the memory, you can always tune
to that channel directly by using the
number buttons on the remote
control.
œ
Note: When Receiving a Digital Cable
Signal : If your cable service signal does
not comply with the ATSC(Advanced
Television System Committee)
requirements, this product may not
operate properly.
6
Press the ENTER button
when channel
memorization is completed.
After pressing ENTER, it
returns to the Channel
menu.
Press the EXIT button to
exit.
5
Press the … or † button
to select the antenna to
memorize, then press the
ENTER button to select
“Start”.
The TV will begin
memorizing all of the
available channels.
Adopts QAM for transmission
Yes
No
T V Auto Program
Select the antennas to memorize
ANT A + ANT B
ANT A
ANT B
T V Auto Program
Start
Start
Start
Channel Memory in Process
CATV Channel 15
Stop
Auto Program
Stop
16 channel were memorized
Air(ANT A) : 7, Cable(ANT B) : 9
Return
Auto Program
When selecting the Cable TV
system:
Press the … or † button to
select “Cable”, then press
the ENTER button.
Press the … or † button to
cycle through these choices:
“STD”, “HRC”, or “IRC”,
then press the ENTER button.
Select the cable system
STD
HRC
IRC
T V Auto Program
Air None
Cable None
Air Cable
Cable Air
ANT A : Air
ANT A : Cable
ANT A : Air, ANT B : Cable
ANT A : Cable, ANT B : Air
4
Press the … or † button to
select antenna connection,
then press the ENTER button.
Select the antenna connection
ANT A ANT B
T V Auto Program
Air None
Cable None
Air Cable
Cable Air
œ STD, HRC, and IRC
identify various types of
cable TV systems. Contact
your local cable company
to identify the type of cable
system that exists in your
particular area.
AA68-03263C-00_eng_Chapter3 3/11/05 4:36 PM Page 32