Filter
Top Products
English _57
! USING THE DVR
Disk End Mode : If selected <Overwrite>, recording will continue despite the HDD full while overwriting the
oldest.
If selected <Stop>, the recording will stop when the HDD is full.
Disk End Beep : If selected <Stop>, the button is activated.
If you check it, the beep will sound on the disk full and the recording stops.
Auto Delete : If you check it, Record Period setup is activated.
If you setup the auto delete, recorded data only in the configured period are searchable.
When the recording option setup is done, press <OK>.
SETTING THE EVENT
You can set recording options for sensor, motion, and video loss event.
Sensor Detection
You can set the sensor’s operating condition and connected camera, as well as alarm output and its duration.
Using the mouse may help make setup easier.
Press the [MENU] button on the remote control or front
panel.
Use the left/right button (
_ +
) to select <Event>.
Event setting menu is selected.
Use the up/down buttons (
▲▼
) to move to <Sensor
Detection>, and press [ENTER] button.
A window of sensor detection setup appears.
Use direction buttons (
▲▼_ +
) to move to a desired
item, and set the value.
Sensor Operation : Sets the operation mode of sensors.
- <OFF
> : Sensor does not operate.
- <N.O (Normal Open)
> : Sensor is opened.
If the sensor is closed, it generates alarm.
- <N.C (Normal Close)
> : Sensor is closed.
If the sensor is open by interruption, it generates alarm.
Cam : Select a channel to be connected to the sensor.
If selected camera, “Cam Preset setup” window appears.
Select a channel and setup the preset.
Preset setup can be done in PTZ mode.
~
~
~
5.
1.
2.
3.
4.
~
~
`
Event
Logout
Exit
Sensor Detection
Motion Detection
Video Loss Detection
Alarm Schedule
Sensor Detection
OK Cancel
Previous/Next Page
Sensor
Sensor Operation
Cam
Alarm
Duration
1 OFF
1 None 10 sec
2 OFF
2 None 10 sec
3 OFF
3 None 10 sec
4 OFF
4 None 10 sec
5 OFF
5 None 10 sec
6 OFF
6 None 10 sec
7 OFF
7 None 10 sec
8 OFF
8 None 10 sec
Sensor Detection
OK Cancel
Previous/Next Page
Sensor
Sensor Operation
Cam
Alarm
Duration
1 OFF
1 None 10 sec
2 OFF
2 None 10 sec
3 OFF
3 None 10 sec
4 OFF
4 None 10 sec
5 OFF
5 None 10 sec
6 OFF
6 None 10 sec
7 OFF
7 None 10 sec
8 OFF
8 None 10 sec
Cam Preset setup
OK Cancel
CH
Preset
1 None
2 None
3 None
4 None
5 None
6 None
7 None
8 None
CH
Preset
9 None
10 None
11 None
12 None
13 None
14 None
15 None
16 None