Filter
Top Products
English _19
● INSTALLATION
4. Insert the HDD into the bracket groove. Insert one side first
and gently lift up the other side.
5. Align the bracket with installed HDD to the guide of the
case, push it toward the board.
J
Push it firmly until you hear the clicking sound.
IF it is not fully mounted, HDD detection may fail.
6. You can check the HDD map directly on the DVR.
Refer to “Storage Device > HDD Map”. (Page 51)
7. Press it upward so that the front cover is closed.
• Replacing the mounted HDD
1. Open the bracket in the direction of arrow to separate the
holder from the HDD.
2. Open other parts of the bracket wide to separate it from
the holder.
M
Remaining instructions after replacing the HDD is same as in
“Installing the HDD”.
a
b