Filter
Top Products
English _45
● MAIN MENU
• Updating the Software
1. Connect a device storing the software to be updated. (It may take about 30 seconds to recognize the
device.)
Upgradeable devices include USB memory, CD/DVD and network device.
To update the network, the current DVR should have been connected to the network.
Upgrade via the proxy server may not be enabled due to the restricted access.
2. Select <System Management> from <System> window.
3. Select <System Information>.
4. Press <Search> button to display updated image, then the <Search> button switches to <Upgrade>.
The <Upgrade> button will be activated only if the current <Software Version> of the <System Information> is same to
or older than that of <S/W Upgrade>.
5. Press <Upgrade> button to display confirmation popup
for upgrading.
Press <OK> in the “System Upgrade” window.
While updating, it shows the progress.
6. When the updating is done, it automatically restarts.
Do not turn the power off until it finishes restarting.
M
If “Upgrade Failed” appears, retry from the step 4.
When you experience continued failure, consult the service
center for assistance.
When you perform S/W update remotely using Smart Viewer,
it may take a max of 3 minutes to complete the update since
Smart Viewer popped up a confirmation message. This is to
guarantee that the DVR set operates stably. For a faster update,
use the USB cable to connect to the DVR set.
Software Version v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Search
OK
Device Network
Version No S/W Data
DVR Name DVR
S/W Upgrade
System Upgrade
OK Cancel
Current Version v1.0xh_yymmddhhmmss
New Version v1.0xh_yymmddhhmmss
Do you want to upgrade?
Software Version v1.0xh_yymmddhhmmss
Broadcast Format
NTSC
MAC Address 00:00:F0:54:FF:FF
System Management
System Information
Settings
Previous
System Information
Search
OK
Device Network
Version No S/W Data
DVR Name DVR
S/W Upgrade
S/W Upgrade
Software upgrading...