Filter
Top Products
24
3.2.2 Video/Audio connection
1. Camera
Up to 16(SVR-950E: Up to 9) CCTV cameras can be connected to DVR.
Connect the BNC terminal for each camera to the CAMERA IN terminal in the back of this product.
If BNC terminal is only connected to CAMERA IN, a 75Ω terminating resistor is
setup internally.
If connected to both CAMERA IN and CAMERA OUT, the device receiving the
output must setup a terminating resistor of 75Ω.
Since CAMERA OUT terminal is a loop output for the camera input, it should only
be connected and used when there is an image input in CAMERA IN terminal.
If cable connected to the CAMERA OUT terminal is not connected to an external
device and is left exposed, image quality may be adversely affected.
Input video system type (NTSC/PAL) is recognized automatically when the
product power button is pushed. However, if a CCTV using a different system
type is connected to a CAMERA IN terminal during product operation, the
product must be turned OFF and ON again for proper automatic recognition of
the input video system type .
1. Camera
3. Voice
2. Monitor
VGA Monitor
Speake
Main Monitor
Spot Monitor
i
Audio(Line input)
SVR-1650/1640E/1640A
SVR-950E