Filter
Top Products
User’s Manual
14
- Remove a hot-swap drive bay by pulling the handle toward you.
- Using the enclosed screws, secure a SATA hard drive to the hot-swap drive bay. 2 screw
grooves are located on either side of the hot-swap drive bay.
- Insert the hot-swap drive bay into the back of the main frame. Gently push the drive bay until
it reaches the end of the main frame, and then secure it to the frame using the handle. Repeat
the procedure to insert SATA hard drives to the other 3 hot-swap drive bays.
※Caution: SATA hard drives are of different shape on the front and back. When securing a
SATA hard drive to a hot-swap drive bay, please make sure to place the SATA connector on
the opposite side of the handle of the drive bay.