Samsung 3 CRT Television User Manual


 
FCC, IC AND SAFETY INFORMATION
FCC INFORMATION
INSTRUCTIONS TO USER
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio / TV technician for help.
INFORMATION TO USER
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
If necessary, consult your dealer or an
experienced radio/television technician for
additional suggestions. The user may find the
following booklet helpful, prepared by the
Federal Communications Commission. “How
to Identify and Resolve Radio/TV
Interference Problems” This booklet is
available from the U.S. Government Printing
Office, Washington, D.C.20402, Stock
number 004-000-00345-4.
WARNING
User must use properly shielded power
supply cord and interface cables to comply
with the requirements of the FCC.
Provided with this monitor is a detachable
power supply cord with IEC320 style
terminations. It may be suitable for connection
to any UL Listed personal computer with
similar configuration. Before making the
connection insure that the voltage rating of the
computer convenience outlet is the same as
the monitor and that the ampere rating of the
computer convenience outlet is equal to or
exceeds the monitor current rating.
For 120 Volt applications use only UL Listed
Detachable Power cord with NEMA
configuration 5-15P type ( parallel blades )
plug cap. For 240 Volt applications use only UL
Listed Detachable power supply cord with
NEMA configuration 6-15P type ( tandem
blades ) plug cap.
3