Filter
Top Products
11
YOUR NEW DIGITAL TV
Rear Panel Jacks
Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Your TV has several input jacks, so you can connect different A/V components simulta-
neously (i.e., a VCR and a DVD, 2 VCRs, etc.).
For more information on connecting equipment, see page 14~24.
Œ
DVI (Digital Visual Interface)
AUDIO INPUT jacks
Receives the digital audio signals from AVdevices.
´
AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video input jacks of a record-
ing VCR.
ˇÔ
AUDIO INPUT1, 2, 3 jacks
Connect to the audio output jacks of VCRs,
DVD players and similar devices.
¨
VIDEO INPUT1, 2, 3 jacks
Connect to the video output jacks of VCRs,
DVD players and similar devices (Three sets
are available: Video1, Video2 and Video3).
ˆ
DIGITAL VIDEO INPUT
(Digital Visual Interface)
jack
Receives the digital signals from a Set-top Box.
Ø
S-VIDEO INPUT jack
Connect to S-VIDEO output jacks of an S-VHS VCR
or DVD player.
Note: In S-Video mode,Audio Output depends
what kind of audio input source is connected to
the side audio input jacks (AV1).
∏
UPGRADE PORT
For service only.
”
OPTICAL OUTPUT jack
Connect to a Digital Audio component.
’
ANTENNA terminals
Two independent cables or antennas can be con-
nected to these terminals.Use ANTAand ANTB
terminals to receive a signal from VHF/UHF anten-
nas or your cable system.
˝
COMPONENT1, 2
(480i, 480p, 720p, 1080i)
AUDIO/VIDEO INPUT jacks
Connect to the Audio & Video outputs of DVD or
DTV Set-Top-Box.
AA68-03263B-00_eng_Chapter1 4/21/04 5:32 PM Page 11