Filter
Top Products
111
System
Chapter 07
Multi Control
MENU
m : T
System Multi Control ENTER
--
Multi Control
ID Setup
ID Input
MDC Connection
DisplayPort Daisy Chain
00
RS232C MDC
Clone
-
The displayed image may differ depending on the model.
Conguring settings for Multi Control
•
ID Setup
Assign an ID to a set. (Range: 0~99)
Press
or to select a number, and press .
•
ID Input
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
•
MDC Connection
Select a method to connect to MDC to receive the MDC signal.
-
RS232C MDC: Communicate with MDC via the RS232C-stereo cable.
-
RJ45 MDC: Communicate with MDC via the RJ45 cable.
•
DisplayPort Daisy Chain
To display theDP IN video input through the DP OUT output port, select a device connection method from Single
Stream Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices
connected.
―
If Clone is selected, the PC recognizes the two displays as a single monitor.
―
Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, Aspect Ratio,
MagicInfo.
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices
connected.
―
If Expand is selected, the PC recognizes the two displays as separate monitors.
―
The mode functions only on a PC that supports DisplayPort 1.2 MST.
―
For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.