Filter
Top Products
Setting the DVD-VCR Output Channel
Selecting the RF OUT Sound Mode (B/G-D/K)
(Newzealand Model only)
25
GB
VCR
VCR
Your DVD-VCR output channel may need to be changed if the
pictures suffer from interference or if your TV cannot find the
pictures.
Also, you can change the DVD-VCR output channel to adjust the
frequency in which information is displayed on the screen.
1 After pressing the MENU, press the OK or
.
Result
: The Setup menu is displayed.
2 Press the corresponding
,
buttons to select the Install
option.
3 Press the OK or
to select this option.
Result: The
Install menu is displayed.
4 Press the
or
buttons, until the VCR Output CH option is
selected.
5 Select the required output channel (CH21~CH69) by pressing the
OK or
buttons (Australia:CH28 ~ CH69).
CH28 .. CH38 .. CH69
CH21 .. CH36 .. CH69
6 On completion, press RETURN to exit the menu.
Then tune your television again (see page 16).
Auto Setup
Manual Setup
Install
TV System : G
VCR Output CH : CH 36
You can choose the sound mode (B/G or D/K) according to the TV
set connected to your VCR.
1 After pressing the MENU, press the OK or
.
Result: The Setup menu is displayed.
2 Press the corresponding
,
buttons to select the Install
option.
3 Press the OK button to select this option.
Result
: The Install menu is displayed.
4 Press the
or
buttons, until the TV System option is
selected.
5
Press the
¥
or
button to select G or K.
6 On completion, press RETURN to exit the menu.
G
K
Auto Setup
Manual Setup
TV System : G
VCR Output CH : CH 36
Install
Auto Setup
Manual Setup
VCR Output CH : CH 38
Install
Australia Model
Newzealand Model
CH:28
:
CH:38
:
CH:69
CH:21
:
CH:36
:
CH:69
(Australia Model)
(Newzealand Model)
00169N DVD-V70/XSA-GB2 11/14/05 10:11 AM Page 25