Filter
Top Products
16
GB
Tuning Your Television for the DVD-VCR
OPEN/CLOSE
STANDBY/ON
2
4
You must tune your television for the DVD-VCR only if you are not
using a RCA cable
➢ To view pictures from your DVD-VCR when a RCA cable
is used, the television must be set to the audio/video
mode (AV).
1 Switch on the television.
2 Switch on the DVD-VCR by pressing STANDBY/ON on the front of
the DVD-VCR or STANDBY/ON on the remote control.
3 Select a programme position on the television to be reserved for
use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check that the
DVD-VCR starts reading the cassette; if not, press
II
button
.
5 Start a scan on your television or set the television to UHF
channel 36 (Australia:UHF 38 CH).
6 Fine tune the television until the pictures and sound are obtained
clearly.
7 If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the DVD-VCR output channel (see Setting the DVD-VCR
Output Channel on page 25 and Problems and Solutions on page
69).
8 When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
Result
: That programme is now reserved for use with your
DVD-VCR.
00169N DVD-V70/XSA-GB1 11/14/05 9:51 AM Page 16