Filter
Top Products
English - 8
Installing Batteries in the Remote Control
1 Lift the cover at the back of the remote control upward as shown in the figure.
2 Install two AAA size batteries.
➢
Make sure to match the “+” and “–” ends of the batteries with the diagram inside the
compartment.
3 Close the cover as shown in the figure.
➢
Remove the batteries and store them in a cool, dry place if you won’t be using the
remote control for a long time. The remote control can be used up to about 23 feet
(7m) from the TV. (Assuming typical TV usage, the batteries last for about one year.)
➢
If the remote control doesn’t work! Check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?
Switching Your Television On and Off
The mains lead is attached to the rear of the television.
1 Plug the mains lead into an appropriate socket.
➢
The main voltage is indicated on the rear of the television and the frequency is 50 or 60Hz.
2 Press the “ ” button (On/Off) on the front of the television.
The standby indicator on the front of the television lights up.
3 Press the POWER button on the remote control to switch the television on.
The programme that you were watching last is re-selected automatically.
➢
If you have not yet stored any channels, no clear picture appears.
Refer to “Storing Channels Automatically” on page 11 or “Storing Channels Manually” on page 12.
4 To switch your television off, press the “ ” button (On/Off) again.
Operation
Placing the Television in Standby Mode
The television can be placed in standby mode, in order to reduce power consumption and wear of the cathode ray tube.
Standby mode can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1 Press the POWER button on the remote control while viewing.
The television is in standby mode.
2 To switch the television back on, simply press it again.
➢
You can also switch on by pressing the TV ( ), P / , or numeric button.
☛
Do not leave your television in standby mode for long periods of time. Turn your television off by pressing the “ ” button
(On/Off) on the front of the television. It is best to unplug the set from the mains and aerial.
AA68-03784A-X0Eng_UK_VE.indd 8 2006-05-26 ｿﾀﾀ・9:29:12