Filter
Top Products
Step 1: Mount Monitor Brackets to a television with a at back
NOTE: For televisions with a curved back, or an obstruction near the threaded insert see Step 2.
Determine the diameter of the Bolt (G,H,I) your TV requires by hand threading them into the threaded insert on the back of the TV. If you
encounter any resistance stop immediately.
Once you have determined the correct diameter, see the appropriate Diagram below, thread the Bolt through the appropriate Lock Washer
(M,N,O), corresponding Washer (P,Q), Monitor Bracket (B,C), and nally into the TV.
Make sure the Monitor Brackets (B,C) are vertically centered and level with each other.
Tighten the Bolts (G,H,I) securing the Monitor Brackets (B,C) to the monitor.
M4
Diameter Bolt
M6
Diameter Bolt
M5
Diameter Bolt
P
C
M
G
P
C
N
H
Q
B
O
I
Diagram 1
Tension
Knob
Tension
Knob
NOTE: If the horizontal distance between the
threaded inserts on the back of the television
is greater than 8-1/8 inches [206 mm] but less
than 11-1/8 inches [282.5 mm], the locations of
the Monitor Brackets (B & C) may be reversed
from right to left. If the Monitor Brackets
are reversed, the Tension Knobs must be
removed and reinstalled so that they are still
facing out.