33
32
OTHER FUNCTIONS
BLUE BACKGROUND
When there is no picture signal or the signal is weak, the screen reverts to a solid blue color.
Disable this feature to watch very weak signals.
CCD (Closed Caption Decoder)
You can select closed caption mode.
Press CCD button on the remote control to change selections as follows :
TILT COMPENSATION
If you notice a slight tilt of the picture (caused by a geomagnetic effect) you can
compensate for it:
TILT TO THE LEFT NORMAL TILT TO THE RIGHT
OFF CCD1
CCD2 TEXT1 TEXT2
*
Refer to page 33 (CCD)
FUNCTION
BLUE BACK : OFF
CCD : OFF
TILT :
0
BLOCKING
: SEL. +: SET :PREV.
FUNCTION
BLUE BACK : ON
CCD : OFF
TILT :
0
BLOCKING
: SEL. +: SET :PREV.
FUNCTION
BLUE BACK : OFF
CCD : OFF
TILT :
0
BLOCKING
: SEL. +: SET :PREV.
FUNCTION
BLUE BACK : OFF
CCD : CCD 1
TILT :
0
BLOCKING
: SEL. +: SET :PREV.
OTHER FUNCTIONS
CCD :
This TV set incorporates a CCD (Closed Caption Decoder) to enable viewing closed captions
and TEXT broadcasts.
Closed caption and TEXT each has 2 channels (CH1 & CH2).
Closed caption and TEXT information can only be viewed if they are being broadcast by a
television station, or contained in a videotape or videodisc.
Press the CCD button to select CCD mode.
CAPTION OPERATION AND CHARACTERISTICS :
After the set is turned on, caption signals will be displayed on screen (if broadcast) in about
10 seconds. Once activated, the television will always remain in caption mode unless
deactivated by the CCD button.
Captions appear on screen in various positions where they will least interfere with the picture.
Generally captions will be displayed at the top or bottom of the screen.
It is common to see unusual characters or misspelled words appearing in the caption. This is
especially true during a live broadcast as captions are created while the program is in
progress.
QUICK VIEW Button : Press Q.VIEW button on the remote control. The previously viewed
channel will appear on the screen. Press Q.VIEW again to switch back to the original channel.
Repeatedly pressing Q.VIEW switches between these two channels.
DISPLAY BUTTON :
Press DISPLAY button on the remote control. The channel number of
the program you are viewing, the TIMER settings and the current time are displayed in sequence.
The current time remains displayed on the screen, until DISPLAY button is pressed again.
MUTE BUTTON : Press MUTE button on the remote control. The sound of the TV program
being viewed will be reduced to zero and "MUTE" will appear on the screen.
To restore normal sound, press MUTE again.
WIDE BUTTON : This function lets you select between wide and normal screens.
Wide 16 : 9
Normal 4 : 3
NOTES
When any function is displayed on screen, captions cannot be seen. Captions will reappear
after display disappears.
Errors will occur in captioning if the signal is weak or the videotape/videodisc is poorly recorded.
A videotape that has been recorded over numerous times can also cause caption malfunction.
NOTE : Changing the audio volume also restores the sound.
OFF CCD1 CCD2 TEXT1 TEXT2
Press VOL+ to tilt to the left.
Press VOL- to tilt to the right.