Sanyo DP32D13 Flat Panel Television User Manual


 
13
ENGLISH
Need help? www.sanyoctv.com 1-800-877-5032
3. Select the tuning band: Antenna for
external antenna, Cable for cable system,
or through your Set Top Box.
Setup Wizard (3/6)
Please select TV RF tuning band
Move Select
Antenna
Cable
Set Top Box
Previous Cancel
ENTER
4. Press [ENTER] button to start the channel
scan.
Setup Wizard (4/6)
Please check that the RF cable is connected properly.
Scan time may take over 20 minutes.
Move Select
START
Previous Cancel
ENTER
5. The channel scanning is now in process.
The Setup Wizard shows the scanning
process of digital channels first, and then
the analog channels next.
The scanning process will show how
many channels in total have been found.
Please wait while the scanning process is
searching for the available channels in your
area.
To cancel the process, press [ENTER]
button on the remote control.
Setup Wizard (5/6)
Searching CH
Digital Channels Found
Analog Channels Found
Channel 4
8
8
Searching. Please wait
Select
Cancel
50%
ENTER
NOTE:
Once you cancel the Setup Wizard, it will not be
shown again.
6. The Setup Wizard is done now. You may
press [EXIT] button on the remote control to
tune to the first detected channel right away.
Setup Wizard (6/6)
Congratulations. TV Setup is done.
Exit
EXIT
NOTE:
The Setup Wizard will not appear again once you
have completed. For updating or adding channels,
refer to the Add/Skip Channels feature on page 15.